[HCDX]: Increase the MW sensitivity for R-5000

[CDXA <cartas@xxxxxxxxxxxx>]

Hello All,

This mod was found at http://www.mods.dk

27-02-2000 Increase the MW sensitivity for R-5000
From: Rein Faber - rfab@xxxxxxxxx


This modification increases the MW sensitivity of the Kenwood R-5000: 

This will help for MW DX or while using a loop antenna when more gain can
be useful. All mods are performed on the RF board, on the side nearest to
the antenna connectons. 

Jumper R10 with a short length of wire, and cut R11. Cut R9 and put a 470
Ohm resistor in series. 

A quick version of this modification is to clip either one [NOT BOTH] of R9
or R11.


73's

Djaci
------------------------------------------------------------------------
This is a message from CDXA <cartas@xxxxxxxxxxxx>
to hard-core-dx@xxxxxxxxxxxxxxxx list. To unsubscribe the list, send
"unsubscribe hard-core-dx" in mail body to majordomo@xxxxxxxxxxxxxxxxx
For more information, please check http://www.hard-core-dx.com/
or email us, staff@xxxxxxxxxxxxxxxxx
------------------------------------------------------------------------