[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [IRCA] Indoor vertical update
The idea with the balanced feed is that it provides better common-mode
noise pick-up rejection than any type of coax which can have
ground-loop current on the shield.
Mark
-----Original Message-----
From: Steve Byan <stevebyan@xxxxxxx>
To: badx@xxxxxxxxxxxxxx
Cc: ABDX <abdx@xxxxxxxxxxxxxxx>; Mailing list for the International
Radio Clubof America <irca@xxxxxxxxxxxxxxxx>; AM-DX List <am@xxxxxxxxx>
Sent: Thu, 12 Feb 2009 1:25 pm
Subject: Re: Indoor vertical update
On Feb 11, 2009, at 10:12 PM, Craig Healy wrote:
Until now it had been a couple of rooms away fed by a 40' length of >
RG-58 50
ohm coax. There was a significant noise issue and a number of >
birdies that
swamped a number of frequencies. And, some electrical buzz would >
run for 30
seconds on and a minute off. Gave me 2/3rds DX time.
I've taken to using quad-shielded RG-6 (cable TV drop cable). The
garden-variety RG-58 and RG-8 doesn't have enough braid coverage to
give good shielding. You can find quality RG-58 cable like Belden 8259,
but it's expensive. Quad-shielded RG-6 cable has even better shielding
and is cheaply available from Home Depot. You really do need to invest
in a Snap-N-Seal tool and compression coax connectors. The Home Depot
connectors are useless.
I replaced the RG-58 with CAT5 ethernet cable of about the same 40' >
length.
CAT5 is pretty g
ood stuff, and handy where you have a balanced feed.
Best regards,
-Steve
--Steve Byan <stevebyan@xxxxxxx>
Littleton, MA 01460
_______________________________________________
IRCA mailing list
IRCA@xxxxxxxxxxxxxxxx
http://montreal.kotalampi.com/mailman/listinfo/irca
Opinions expressed in messages on this mailing list are those of the original contributors and do not necessarily reflect the opinion of the IRCA, its editors, publishing staff, or officers
For more information: http://www.ircaonline.org
To Post a message: irca@xxxxxxxxxxxxxxxx